Lenovo 6528 Manual do Utilizador descarregar pdf (Página 110)

7. Press the ServeRAID-MR10i adapter firmly into the connector on the system

board.

8. Reconnect the cables to the new ServeRAID-MR10i adapter.

Removing an optional ServeRAID-MR10is VAULT SAS/SATA controller

To remove a ServeRAID-MR10is SAS/SATA adapter, complete the following steps:

1. Read the safety information beginning on page vii, and “Installation guidelines”

on page 29.

2. Turn off the server and peripheral devices, and disconnect the power cords and

all external cables. Remove the side cover (see “Removing the side cover” on

page 32).

3. Rotate the rear adapter-retention bracket to the open (unlocked) position.

4. Open the rear retention bracket.

5. Disconnect any cables connected to the adapter.

Attention: To avoid breaking the retaining clips or damaging the

ServeRAID-MR10is adapter connector, open and close the clips gently.

6. Carefully grasp the end of the ServeRAID adapter and pull it out of the

connector.

7. If you are instructed to return the adapter, follow all packaging instructions, and

use any packaging materials for shipping that are supplied to you.

Installing an optional ServeRAID-MR10is VAULT SAS/SATA Controller

The optional IBM ServeRAID-MR10is VAULT SAS/SATA controller can be installed

in either PCI slot 1 or slot 2 on the system board. The ServeRAID-MR10is adapter

is supported on hot-swap server models only. The erveRAID-MR10is SAS/SATA

adapter with an encryption 1078 DE chip set enables integrated RAID levels 0, 1, 5,

6, and 10 support capability on hot-swap hard disk drives. For configuration

information, see the documentation on the ServeRAID CD that comes with the

adapter.

Important: To ensure that any of your ServeRAID 10i, 10is, or 10M adapters

function properly on UEFI-based servers, make sure that the adapter firmware level

is updated to at least 11.xx-XXX, and the supporting drivers.

Attention: Some cluster solutions require specific code levels or coordinated code

updates. If the device is part of a cluster solution, verify that the latest level of code

is supported for the cluster solution before you update the code.

To install the optional ServeRAID-MR10is SAS/SATA adapter, complete the

following steps:

1. Read the safety information beginning on page vii, and “Installation guidelines”

on page 29.

2. Touch the static-protective package containing the ServeRAID-MR10is adapter

to any unpainted metal surface on the server. Then, remove the

ServeRAID-MR10is adapter from the package.

3. If the battery pack (battery carrier and battery) did not come installed on the

ServeRAID adapter, install the battery pack.

a. Align the battery carrier pins and the connector for the battery carrier with

the pin holes and connector on the ServeRAID adapter; then, lower the

battery carrier onto the ServeRAID adapter.

94 ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 215 216

Comentários a estes Manuais

Sem comentários

Lenovo 6528 Manual do Utilizador Página 110

Comentários a estes Manuais

Manuais e produtos relacionados com Computadores Lenovo 6528