Lenovo 6528 Manual do Utilizador descarregar pdf (Página 87)

Connecting the cables

Attention: To prevent damage to equipment, connect the power cords last.

If the server cables and connector panel have color-coded connections, match the

color of the cable end with the color of the connector. For example, match a blue

cable end with a blue panel connector, a red cable end with a red connector, and

so on.

See “Rear view” on page 18 for an illustration of the input/output (I/O) connectors

on the rear of the server.

Updating the server configuration

When you start the server for the first time after you add or remove a device, you

might receive a message that the configuration has changed. The Setup Utility

starts automatically so that you can save the new configuration settings. For more

information, see Chapter 7, “Configuring the server,” on page 109.

Some optional devices have device drivers that you must install. For information

about installing device drivers, see the documentation that comes with each device.

The server comes with at least one microprocessor. If more than one

microprocessor is installed, the server can operate as a symmetric multiprocessing

(SMP) server. You might have to upgrade the operating system to support SMP. For

more information, see the operating-system documentation.

If the server has an optional RAID adapter and you have installed or removed a

hard disk drive, see the documentation that comes with the RAID adapter for

information about reconfiguring the disk arrays.

For information about configuring the integrated Gigabit Ethernet controller, see

“Configuring the Gigabit Ethernet controller” on page 122.

Connecting external devices

If you install a supported optional adapter, you can attach external devices to the

server.

To attach an external device, complete the following steps:

1. Read the safety information that begins on page vii, “Installation guidelines” on

page 29, and the documentation that comes with the device.

2. Turn off the server and all attached devices.

3. Follow the instructions that come with the device to prepare it for installation

and to connect it to the server.

Note: If you are attaching an external device, see the documentation that comes

with the device for information about cabling.

Chapter 5. Installing and replacing optional devices 71

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 215 216

Sem comentários

Lenovo 6528 Manual do Utilizador Página 87