Lenovo 6528 Manual do Utilizador descarregar pdf (Página 66)

To remove a hot-swap hard disk drive, complete the following steps:

1. Read the safety information that begins on page vii and “Installation guidelines”

on page 29.

Note: You do not have to turn off the server to remove hot-swap drives from

the hot-swap drive bays.

2. Remove the lower bezel (see “Removing the two-piece bezel” on page 34).

3. Rotate the drive tray handle of the drive assembly that is to be removed to the

open position (based on your model).

1 Drive-tray assembly

2 Drive tray handle (in open position)

4. Grasp the handle of the drive assembly that is to be replaced and pull the

assembly out of the bay.

5. If you are instructed to return the drive assembly, follow all packaging

instructions, and use any packaging materials for shipping that are supplied to

you.

IDs for hot-swap hard disk drives

On some models, the hot-swap-drive backplane controls the IDs of the internal

hot-swap drive bays. The following table lists the IDs of the hard disk drives and

backplane that are connected to one channel in the hot-swap models. In the typical

configuration, the standard hard disk drives and backplane are connected to

channel A. This table applies only to server models that support four hard disk

drives.

50 ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 215 216

Sem comentários

Lenovo 6528 Manual do Utilizador Página 66